Installation guide
Every CarPlay interface is plug-and-play — the harness connects behind the factory head unit with no wire cutting, no coding, and the original screen stays.
Remove the head unit or screen
Remove the factory head unit or display trim to access the rear connectors.
Connect the harness
Plug the vehicle-specific harness in-line between the factory display and its original connection.
Mount the interface
Secure the interface module behind the dash and route the cables cleanly.
Pair and test
Pair your phone, then verify CarPlay / Android Auto, original controls and any added camera.
Everything you need for a clean install
Vehicle-specific harness
Matched connectors for each factory system — no splicing, no soldering.
Wiring diagrams
Clear diagrams and step-by-step notes shipped with every kit.
Technical support
Direct support with remote diagnosis for tricky installs and firmware issues.
Fitting an AUX activator on a BMW CCC car? That procedure is different from an interface install and has its own illustrated sheet — read it before you take the screen out, because the unit is single-use.
Questions about installation?
Our team can help you or your installer before and after purchase.